Ford Escape: Evaporative Emissions / Removal and Installation - Evaporative Emission System Leak Detection Pump - Hybrid Electric Vehicle (HEV)
Removal
NOTE:
The evaporative emission system leak detection pump is serviced with the EVAP canister
-
Refer to: Evaporative Emission Canister - Hybrid Electric Vehicle (HEV)
(303-13C Evaporative Emissions, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
The evaporative emission system leak detection pump is serviced with the EVAP canister
Refer to: Evaporative Emission Canister - Plug-In Hybrid Electric
Vehicle (PHEV) (303-13C Evaporative Emissions, Removal and
Installation)...
Removal
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of
any type when working on or near any fuel-related component...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCMC
U010..
Special Tool(s) /
General Equipment
Trolley Jack
Wooden Block
Removal
Drain the Electric Powertrain Cooling System.
Refer to: Cooling System Filling and Bleeding (303-03D Electric
Powertrain Cooling - Hybrid Electric Vehicle (HEV), General Procedures).
Disable the vehicle high-voltage electrical system.
Refer to: High Voltage System De-energizing (414-0..
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more