Ford Escape: Moonroof (If Equipped) / Opening and Closing the Sun Shade
WARNING: Do not leave children
unattended in your vehicle and do not
let them play with the sun shades.
Failure to follow this instruction could
result in personal injury.
The controls are on the overhead console.
Opening the Sun Shade
Press and release the switch to
activate the one-touch open
feature. To stop movement,
press the switch a second time. The sun
shade also opens when you open the
moonroof.
Note: The sun shade stops short of its fully
opened position for the comfort of rear
passengers. To fully open the sun shade,
press the switch again.
Closing the Sun Shade
Press and release the switch to
activate the one-touch close
feature. To stop movement,
press the switch a second time.
WARNING: Do not leave children
unattended in your vehicle and do not
let them play with the moonroof. Failure
to follow this instruction could result in
personal injury...
Other information:
Overview
The perimeter anti-theft alarm system has three operation modes:
ARMED - The perimeter anti-theft alarm is armed when the
ignition is OFF and all vehicle entry points have been electrically
locked for 20 seconds.
ACTIVE - When the perimeter anti-theft alarm activates,
the horn sounds and all turn signals and interior courtesy lamps flash...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Using a non-marring tool release and position the light sensor.
Use the General Equipment: Interior Trim Remover
Disconnect the electrical connector and remove the light sensor...
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more