Ford Escape 2020-2025 Owners Manual / Keys and Remote Controls / Sounding the Panic Alarm. Locating Your Vehicle

Ford Escape: Keys and Remote Controls / Sounding the Panic Alarm. Locating Your Vehicle

Sounding the Panic Alarm

Ford Escape. Sounding the Panic Alarm. Locating Your Vehicle Press the button to sound the panic alarm. Press the button again, or switch the ignition on to turn it off.

Note: The panic alarm only operates when the ignition is off.

Locating Your Vehicle

Ford Escape. Sounding the Panic Alarm. Locating Your Vehicle Press the lock button twice within three seconds. The turn signal lamps flash.

Note:We recommend you use this method to locate your vehicle.

Opening and Closing the Flip Key. Removing the Key Blade

Opening Your Flip Key Press the round button on the remote control to extend the flip key. Note: Inspect the key blade for debris. Periodically clean with a brush...

Changing the Remote Control Battery - Vehicles With: Push Button Start

WARNING: Keep batteries away from children to prevent ingestion. Failure to follow this instruction could result in personal injury or death. If ingested, immediately seek medical attention...

Other information:

Ford Escape 2020-2025 Service Manual: Removal and Installation - Powertrain Control Module (PCM)

Special Tool(s) / General Equipment 418-537Drill Bushing, Powertrain Control Module Ford Diagnostic Equipment 6 mm Drill Bit Removal All vehicles NOTE: Removal steps in this procedure may contain installation details. NOTE: This step is only necessary when installing a new component...

Ford Escape 2020-2025 Owners Manual: Fuel Quality

Selecting the Correct Fuel Choosing the Right Fuel Your vehicle operates on regular unleaded gasoline with a minimum pump (R+M)/2 octane rating of 87. Some fuel stations, particularly those in high altitude areas, offer fuels posted as regular unleaded gasoline with an octane rating below 87...

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.