Ford Escape: General Information / Description and Operation - Diesel Fuel System Health and Safety Precautions
WARNING:
Do not work on the fuel system until the pressure has been
released and the engine has cooled. Fuel in the high-pressure fuel
system is hot and under very high pressure. High-pressure fuel may cause
cuts and contact with hot fuel may cause burns. Failure to follow these
instructions may result in serious personal injury.
This
document provides critical diagnostic knowledge required for successful
repair outcomes. It identifies technical competencies expected by users
of this manual...
WARNING:
Always allow the engine to cool before opening the cooling
system. Do not unscrew the coolant pressure relief cap when the engine
is operating or the cooling system is hot...
Other information:
System Operation
System Diagram - Memory Seat
Item
Description
1
Memory Power Seat Motors
2
HS1-CAN
3
PCM
4
BCM
5
HS1-CAN
6
Ignition Switch
7
GWM
8
Memory SET Switch
9
Driver Seat Control Switch
10
MS-CAN
11
DSM
12
MS-CAN
13
DDM
14
Position Sensors
15
Motors
Network Message..
Towing a Trailer Precautions
WARNING: Do not exceed
the GVWR or the GAWR
specified on the certification
label.
WARNING: Towing trailers
beyond the maximum
recommended gross trailer
weight exceeds the limit of your
vehicle and could result in engine
damage, transmission damage,
structural damage, loss of
vehicle control, vehicle rollover
and personal injury.
WARNING: Do not exceed
the l..
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more