Other information:
Special Tool(s) /
General Equipment
100-002
(TOOL-4201-C)
Holding Fixture with Dial Indicator Gauge
303-507Timing Peg, Crankshaft TDCTKIT-2001N-FLMTKIT-2001N-ROW
Check
Install Special Service Tool: 303-507
Timing Peg, Crankshaft TDC.
Rotate the crankshaft slowly clockwise until the crankshaft balance
weight is up against the Crankshaft TDC Tim..
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the rear door latch.
Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
NOTE:
This step is only necessary when installing a new component.
NOTE:
Follow the unique instructions or graphic for this step in installation.
Release the ..