Ford Escape: Glass, Frames and Mechanisms / General Procedures - Power Door Window Initialization - Vehicles With: One-Touch Open and Close Front Windows
Initialization
-
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
-
WARNING:
Keep objects and body parts clear of the glass panel
when carrying out the initialization procedure. During the
initialization procedure, the glass panel closes with high force and
cannot detect objects in its path. Failure to follow this instruction
may result in serious personal injury.
NOTE:
Make sure that the window runs are correctly installed and free of foreign material.
Start the engine.
-
Press and hold the window control switch until the door window is fully open.
-
Release the window control switch.
-
NOTE:
All of the remaining steps must be carried out within 30 seconds from start to finish.
Lift and hold the window control switch until the door window stalls in the fully closed position for 2 seconds.
-
Release the window control switch.
-
Press and hold the window control switch until the door window stalls in the fully open position for 2 seconds.
-
Release the window control switch.
-
Lift and hold the window control switch until the door window stalls in the fully closed position for 2 seconds.
-
Test for correct window operation by carrying out the one-touch down and one-touch up features.
Materials
Name
Specification
Motorcraft® Ultra-Clear Spray Glass CleanerZC-23
ESR-M14P5-A
Repair
Bring the vehicle up to at least the specified room temperature or above...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the driver door window control switch and bezel as an assembly...
Other information:
Adjustment
NOTE:
If the flash video link does not load or is
incompatible with your browser, a .wmv version of the video can be
accessed at:
http://www.fordservicecontent.com/Ford_Content/videos/FusionHeadlampAdj2.wmv
Click on the link above to view video...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the diagnostic scan tool
prior to removing the module. This information must be downloaded into
the new module after installation...