Ford Escape: Engine System - General Information / General Procedures - Valve Stem Diameter
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
-
Measure the diameter of each intake and exhaust valve
stem at the points shown. Verify the diameter is within specification.
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion chamber side of the
valve guide, if necessary...
Valve Train Analysis - Engine Off, Valve Cover Removed
NOTE:
The following component inspections are used to diagnose valve train concerns.
Check for damaged or severely worn parts and correct assembly...
Other information:
Special Tool(s) /
General Equipment
Hose Clamp Remover/Installer
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles...
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
Removal
Remove the front halfshaft RH .
Remove and discard the circlip and O-ring seal from the intermediate shaft...