Ford Escape: Windows / Opening and Closing the Windows
WARNING: Do not leave children
unattended in your vehicle and do not
let them play with the power windows.
Failure to follow this instruction could
result in personal injury.
WARNING: When closing the
power windows, verify they are free of
obstruction and make sure that children
and pets are not in the proximity of the
window openings.
Press the window control switch
to open the window. Lift the
window control switch to close
the window.
To reduce wind noise or pulsing noise when
just one window is open, slightly open the
opposite window.
One-Touch Down (If Equipped)
Press the window control switch fully and
release it. Press again or lift it to stop the
window.
One-Touch Up (If Equipped)
Lift the window control switch fully and
release it. Press or lift it again to stop the
window.
Resetting One-Touch Up
- Start the engine.
- Lift and hold the window control switch
until you fully close the door window.
Continue to hold the window control
switch for a few seconds after you
close the window.
- Release the window control switch.
- Press and hold the window control
switch until you fully open the door
window.
- Release the window control switch.
- Lift and hold the window control switch
until you fully close the window.
- Test for correct window operation by
carrying out the one-touch down and
one-touch up features.
Accessory Delay
The window switches remain operational
for several minutes when you switch the
ignition off or until you open either front
door.
Window Bounce-Back
(If Equipped)
What Is Window Bounce-Back
The window stops and reverses some
distance if it detects an obstacle when
closing.
Overriding Window Bounce-Back
WARNING: If you override
bounce-back, the window does not
reverse if it detects an obstacle...
Other information:
System Operation
Air Fuel Ratio Imbalance Monitor
The air fuel ratio imbalance monitor is an on board diagnostic strategy designed to monitor the air fuel ratio.
Air Fuel Ratio Imbalance Monitor — Heated Oxygen Sensor (HO2S) Monitor
The air fuel ratio imbalance monitor estimates the cylinder to
cylinder air fuel ratio difference using the universal HO2S
high frequency signal...
Overview
The
high voltage battery charging system is responsible for charging the
high voltage battery while the vehicle is not operating. It consists of
an Electric Vehicle Supply Equipment (EVSE), SOBDM and Charge Status Indicator (CSI).
The EVSE is an external AC
charger that connects to an external voltage source and the vehicle
charge port when the vehicle is not operating to charge t..