Ford Escape: MyKey™ / Programming a MyKey. Clearing All MyKeys. Checking MyKey System Status.
Using MyKey With Remote Start Systems
Programming a MyKey
You can program any remote control to
become a restricted MyKey, but you must
leave one unmodified as an admin key.
- Switch the ignition on using an admin
key.
- Press Settings on the touchscreen.
- Press Vehicle Settings.
- Press MyKey.
- Select a setting and press the OK
button.
- Configure the setting
Clearing All MyKeys
restrictions and return all MyKeys to their
original admin key status.
- Switch the ignition on using an admin
key.
- Press Settings on the touchscreen.
- Press Vehicle Settings.
- Press MyKey.
- Press Clear All MyKeys.
- Press Yes.
Checking MyKey System Status
You can find information about the
distance traveled using a MyKey, and the
number of admin keys and MyKeys created
for your vehicle.
- Switch the ignition on.
- Press Settings on the touchscreen.
- Press Vehicle Settings.
- Press MyKey.
- Press MyKey Information.
Using MyKey With Remote Start Systems
MyKey is not compatible with unapproved,
aftermarket remote start systems. If you
choose to install a remote start system,
see an authorized dealer for an approved
remote start system.
Creating a MyKey - Vehicles With: Push Button Start
Remove the mat covering the backup
location.
Remove the key blade from the
transmitter.
Place the passive key in the position
shown, with the buttons facing upward...
MyKey – Information Messages - Vehicles With: Push Button Start
MyKey – Information Messages - Vehicles With: Flip Key
MyKey – Frequently Asked Questions - Vehicles With: Push Button Start
What is an admin key?
An admin key is a key that you have
not created as a MyKey...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
Module
DTC
Description
Action
BCM
B130F:12
Run Accessory Control: Circuit Short To Battery
GO to Pinpoint Test A
BCM
B130F:14
Run Accessory Control: Circuit Short To Ground Or Open
GO to Pinpoint Test A
BCM
B13A4:11
Front ..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear head restraint guide sleeves.
Refer to: Rear Head Restraint Guide Sleeve (501-10B Rear Seats, Removal and Installation).
Remove the LH rear seat cushion.
Refer to: Rear Seat Cushion Cover (501-10B Rear Sea..