Ford Escape Manuals

Ford Escape: Remote Start / Remote Start Settings

Switching Climate Control Auto Mode On and Off

  1. Press Settings on the touchscreen.
  2. Press Remote Start Setup.
  3. Press Climate Control.
  4. Select Vehicle.
  5. Switch Auto on or off.

Note: If you switch the auto mode on, the system attempts to heat or cool the interior to 72°F (22°C).

Note: When you switch the ignition on, the climate control system returns to the last used settings.

Switching Climate Control Last Settings On and Off

  1. Press Settings on the touchscreen.
  2. Press Vehicle Settings.
  3. Press Remote Start Setup.
  4. Switch Last settings on or off.

Note: If you switch the last settings on, the system remembers the last used settings.

Switching the Heated Seat Settings On and Off

  1. Press Settings on the touchscreen.
  2. Press Vehicle Settings.
  3. Press Remote Start Setup.
  4. Press Seats.
  5. Switch Auto on or off.

Note: If you switch the heated seat settings on, the heated seats turn on during cold weather.

Switching the Heated Steering Wheel Settings On and Off

  1. Press Settings on the touchscreen.
  2. Press Vehicle Settings.
  3. Press Remote Start Setup.
  4. Press Seats and Steering Wheel.
  5. Switch Auto on or off.

Note: If you switch the heated steering wheel settings on, the heated steering wheel turns on during cold weather.

Setting the Remote Start Duration

  1. Press Settings on the touchscreen.
  2. Press Vehicle Settings.
  3. Press Remote Start Setup.
  4. Press Duration.

Note: Wait a few seconds before remotely starting the vehicle after the vehicle stops running.

    Extending the Remote Start Duration. Remote Start Remote Control Indicators

    Extending the Remote Start Duration To extend the remote start duration during remote start, do the following: Press the button on the remote control...

    Climate Control

    ..

    Other information:

    Ford Escape 2020-2025 Service Manual: Removal and Installation - Steering Gear


    Removal Remove the front subframe. Refer to: Front Subframe (502-00 Uni-Body, Subframe and Mounting System, Removal and Installation). Remove and discard the steering gear retainers. Position the steering gear to the RH side then remove it from the front subframe. NOTE: This step is only necessary when installing a new co..

    Ford Escape 2020-2025 Service Manual: General Procedures - Wheel to Hub Runout Minimization


    Check NOTE: Wheel-to-hub optimization is important. Clearance between the wheel and hub can be used to offset or neutralize the Road Force® or run-out of the wheel and tire assembly. For every 0.001 inch of wheel-to-hub clearance, the Road Force® can be affected between 1 and 3 pounds depending on the tire stiffness. NOTE: The example below illustrates how the clearance betw..

    Categories

    Push Button Ignition Switch

    Ford Escape. Push Button Ignition Switch

    Switching the Ignition Off

    When the ignition is on or in accessory mode, press the push button ignition switch once without your foot on the brake pedal.

    read more

    Copyright © 2025 www.fordescape4.com