Ford Escape: Handles, Locks, Latches and Entry Systems / Removal and Installation - Fuel Filler Door Latch

Removal and Installation - Front Door Lock Control Switch

Removal NOTE: LH (left-hand) side shown, RH (right-hand) side similar. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Removal and Installation - Hood Latch

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the air cleaner inlet pipe. Refer to: Air Cleaner Intake Pipe (303-12C Intake Air Distribution and Filtering, Removal and Installation)...

Other information:

Ford Escape 2020-2026 Service Manual: Description and Operation - Brake and Clutch Systems Health and Safety Precautions

  WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury...

Ford Escape 2020-2026 Service Manual: General Procedures - Intake Manifold Vacuum Test

Bring the engine to normal operating temperature. Connect the Vacuum/Pressure Tester to the intake manifold. Run the engine at the specified idle speed. The vacuum gauge should read between 51-74 kPa (15-22 in-Hg) depending upon the engine condition and the altitude at which the test is conducted...