Ford Escape: Roof Opening Panel / Removal and Installation - Roof Opening Panel Fixed Glass
Removal
-
Remove the roof opening panel fixed glass.
Refer to: Fixed Glass (501-11 Glass, Frames and Mechanisms, General Procedures).
Installation
-
To install, reverse the removal procedure.
Removal
The roof opening panel control switch is replaced as an assembly with the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation)...
Special Tool(s) /
General Equipment
Power Caulk Gun
Power Fixed Glass Removal Tool
Knife
Adhesive Tape
Materials
Name
Specification
Sika® SikaTack® MACH 60 / Sika® SikaTack® MACH 30 / Dow® BETASEAL™ Express
-
Sika® Aktivator PRO / Dow® BETAPRIME™ 5504G / Sika® Primer-207
-
Removal
NOTE:
Removal steps in this procedure may..
Other information:
NOTE:
On vehicles equipped with Trailer Reverse Guidance (TRG)
complete this procedure and also perform the Trailer Reverse Guidance
camera alignment.
Using a scan tool select the controlling module for the parking aid camera(s).
Refer to the wiring diagram to identify the camera controlling module. Refer to Wiring Diagrams Cell 145 for schematic and connector information.
..
Removal
Release the clips and remove the floor console upper rear trim panel.
Disconnect the electrical connectors.
Remove the PATS center antenna.
Remove the nuts.
Lift upward on the PATS center antenna.
Disconnect the electrical connector.
Installation
To install, reverse t..