Ford Escape 2020-2026 Service Manual / Chassis / Driveline / Driveshaft / Specifications

Ford Escape: Driveshaft / Specifications

Item	1.5L EcoBoost	2.0L EcoBoost	2.5L Duratec HEV
Driveshaft runout	0.6 mm (0.024 in)	0.6 mm (0.024 in)	0.6 mm (0.024 in)
Driveshaft to transfer case flange joint angle (transfer case-end driveshaft tube relative to transmission pan)	3.2°	3.2°	3.3°
Driveshaft center bearing joint angle (transfer case-end driveshaft tube relative to RDU -end driveshaft tube)	0.5°	0.5°	0.5°
Driveshaft to RDU CV -joint angle ( RDU -end driveshaft tube relative to rear axle housing locator pad)	2.9°	2.9°	2.9°

Driveshaft

Diagnosis and Testing - Driveshaft

Symptom Chart(s) Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - Radio Transceiver Module (RTM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation...

Ford Escape 2020-2026 Service Manual: Description and Operation - Plastic Repairs

Plastic Components The following illustration(s) are not all-inclusive of trim levels available. The actual trim level of the vehicle will determine the viability of carrying out a plastics repair. Typically components with moulded-in color or a textured finish are not considered repairable components...

Under Hood Fuse Box

Locating the Under Hood Fuse Box

Ford Escape. Under Hood Fuse Box

Accessing the Under Hood Fuse Box