Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the stoplamp switch electrical connector.
NOTICE:
Do not press, pull or otherwise move the brake pedal
while installing the stoplamp switch and cruise control deactivation
switch. Install these switches with the booster push rod attached to the
brake pedal a..
System Operation
Fuel Systems
The fuel system supplies the fuel injectors with clean fuel at a
controlled pressure. The PCM controls the fuel pump and monitors the
fuel pump circuit. The PCM
controls the fuel injector ON/OFF cycle duration and determines the
correct timing and amount of fuel delivered. When a new fuel injector is
installed it is necessary to reset the learned values conta..