Ford Escape: Radio Frequency Certification Labels / Body Control Module
Argentina

Ghana


Jamaica


Mauritania


Morocco


Paraguay

2020-07-I-0405
Serbia

Singapore

South Africa


South Korea

R-R-175-P005
United Arab Emirates (U.A.E.)

United States and Canada
WARNING: Changes or
modifications not expressively approved
by the party responsible for compliance
could void the user's authority to operate
the equipment. The term "IC:" before the
radio certification number only signifies
that Industry Canada technical
specifications were met.
FCC ID: LXPP004
IC: 2298A-P004
This device complies with Part 15 of the
FCC Rules and with Innovation, Science
and Economic Development Canada’s
licence-exempt RSS(s). Operation is
subject to the following two conditions:
- This device may not cause harmful
interference, and
- This device must accept any
interference received, including
interference that may cause undesired
operation.
Zambia

Argentina
Brazil
China
CMIIT ID: 2015DJ1610
Djibouti
European Union EU
Ghana
Jamaica
Malaysia
RALM/24A/0715/S(15-2272)
Mauritania
Moldova
Pakistan
Paraguay
Serbia
Singapore
South Africa
South Korea
MSIP-CRM-8DC-SRR3B
Taiwan, China
Ukraine
United Arab Emirates (U...
Argentina
Brazil
Djibouti
Ghana
Indonesia
Jamaica
Malaysia
RALM/61A/0318/S(18-0852)
Mauritania
Moldova
Morocco
Pakistan
Paraguay
Serbia
Singapore
South Africa
South Korea
R-CMM-DLH-L2C0065TR
Syria
Taiwan, China
Ukraine
United Arab Emirates
United States and Canada
WARNING: Changes or
modifications not expressively approved
by the party responsible for compliance
could void..
Other information:
Special Tool(s) /
General Equipment
Punch
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the aft rear door upper moulding.
Refer to: Rear Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Remove the upper inter..
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service expense. Use the same or equivalent parts if
replacement is necessary. Do not use a replacement part of lesser
quality or substitute design. Tighten fasteners as specified.
NOTE:
Removal steps in this procedure may ..