Ford Escape: Body and Paint / Body Repairs - General Information

Removal and Installation - Side Curtain Airbag

Removal   WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully...

Specifications

  General Specifications Item Specification Plastic front fascia paint maximum thickness 12 mils (300 microns) Plastic rear fascia paint maximum thickness 12 mils (300 microns)   General Specifications Item Specification Plug Weld hole 8 m..

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Exhaust Manifold Cleaning and Inspection

Special Tool(s) / General Equipment Feeler Gauge Cleaning Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces. Inspection NOTE: New exhaust manifold gaskets, studs, nuts and/or bolts must be installed when an exhaust manifold is serviced. NOTE: Use a Straightedge that is calibrated by the ..

Ford Escape 2020-2026 Service Manual: Removal and Installation - Axle Assembly

Special Tool(s) / General Equipment Transmission Jack Wooden Block Removal NOTE: Removal steps in this procedure may contain installation instructions. Remove the rear halfshafts. Refer to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation). Remove the fuel tank. Refer to: Fuel Tank - FWD (310-01A Fuel Tank and Lines - 1.5L EcoBoos..