Ford Escape 2020-2026 Service Manual / Chassis / Brake System

Ford Escape: Chassis / Brake System

Removal and Installation - Rear Halfshaft

Special Tool(s) / General Equipment 100-001 (T50T-100-A) Slide Hammer 205-832Remover, HalfshaftTKIT-2006C-FFMFLMTKIT-2006C-LMTKIT-2006C-ROW Removal NOTICE: Never pick up or hold the halfshaft by only the inner or outer Constant Velocity (CV) joint...

Brake System - General Information

Other information:

Ford Escape 2020-2026 Service Manual: Description and Operation - Electronic Engine Controls - System Operation and Component Description

System Operation Comprehensive Component Monitor (CCM) The comprehensive component monitor (CCM) checks for concerns in any powertrain electronic component or circuit that provides input or output signals to the PCM that can affect emissions and is not monitored by another OBD monitor. Inputs and outputs are, at a minimum, monitored for circuit continuity or correct range of values. Where..

Ford Escape 2020-2026 Service Manual: Removal and Installation - Coolant Pump

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03C Engine Cooling, General Procedures). Disconnect the electrical connector. Release the clamps and disconnect the coolant hoses. Use the General Equipme..

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.