Ford Escape: Wipers and Washers / Checking the Wiper Blades. Replacing the Front Wiper Blades. Replacing the
Rear Wiper Blades
Checking the Wiper Blades

Run the tip of your fingers over the edge of
the blade to check for roughness.
Replacing the Front Wiper Blades

- Lift the wiper arm and then press the
wiper blade locking buttons together.
Note: Do not hold the wiper blade to
lift the
wiper arm.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
- Slightly rotate the wiper blade.
- Remove the wiper blade.
- To install, reverse the removal
procedure.
Replacing the Rear Wiper Blades

- Lift the wiper arm.
Note: Do not hold the wiper blade to lift the
wiper arm.
- Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
- To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.
Switching the Rear Window Wiper On and Off
Intermittent wipe.
Continuous wipe.
Rear window wiper off.
Reverse Wipe
What Is Reverse Wipe
Reverse wipe turns on the rear window
wiper when you shift into reverse (R) and
the windshield wipers are on...
Washer Precautions
WARNING: If you operate your
vehicle in temperatures below 41°F
(5°C), use washer fluid with antifreeze
protection. Failure to use washer fluid
with antifreeze protection in cold
weather could result in impaired
windshield vision and increase the risk
of injury or accident...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Using a non-marring tool, release and position the headlamp switch out.
Use the General Equipment: Interior Trim Remover
Disconnect the electrical connector and remove the headlamp switch...
NOTE:
If an overnight drive is done, the fan air or road air blast can cause erroneous readings.
NOTE:
When diagnosing engine oil leaks, the source and location of the leak must be positively identified prior to repair.
Prior to carrying out this procedure, clean the cylinder
block, cylinder heads, valve covers, oil pan and flywheel/flexplate with
a suitable solvent to remove al..