Ford Escape 2020-2025 Service Manual / Electrical / Climate Control System

Ford Escape: Electrical / Climate Control System

Electrical

Climate Control System - General Information

Other information:

Ford Escape 2020-2025 Service Manual: General Procedures - Refrigerant System Tests - 2.0L EcoBoost (177kW/240PS) – MI4

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: Proper A/C system diagnosis on a vehicle’s compressor is dependent on correct refrigerant system charge and tested in ambient temperatures above 21°C (70°F). Perform the following steps to achieve normal operating pressures. Drive the vehicle or run the engine until it reaches normal operati..

Ford Escape 2020-2025 Service Manual: Removal and Installation - C-Pillar Side Impact Sensor

Removal WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash. NOTE: LH (left-hand) shown, RH (right-..

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.