Ford Escape Manuals

Ford Escape: SYNC™ 3 (If Equipped) / Entertainment

Ford Escape. Entertainment

  1. Audio source. Select to choose a different audio source.
  2. Presets. Swipe left to view more presets.

You can access these options using the touchscreen or voice commands.

Sources

Press this button to select the source of media you want to listen to.

Ford Escape. Entertainment

1 This feature may not be available in all markets and requires an active subscription.

Voice Settings Commands

You can say the following commands to access the voice settings: You can use the volume control to adjust the volume of the system voice prompts. While prompt is active, adjust the volume control up or down to your desired setting...

AM/FM Radio

Tuning a Station You can use the tune or seek controls on the radio bezel to select a station. To tune a station using the touchscreen, select: A pop up appears, allowing you to type in the frequency of a station...

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Cylinder Bore Taper


Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper...

Ford Escape 2020-2026 Service Manual: Diagnosis and Testing - Noise, Vibration and Harshness (NVH)


Special Tool(s) Vehicle Communication & Measurement Module (VCMM™) Base Kit 164-R9822 / 164-R9823 EngineEAR107-R2100Chassis EarsJSP97170 Squeak And Rattle Kit164-R4900 Ultrasonic Diagnostic ToolTRATP-9367 Diagnostic Theory The shortest route to an accurate diagnosis results from: System knowledge, including comparison with a..

Categories

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.

read more

Copyright © 2026 www.fordescape4.com