Ford Escape: Climate Control System / Supplemental Climate Control

Removal and Installation - Thermostatic Expansion Valve Manifold and Tube Assembly - 1.5L EcoBoost (132kW/180PS) – I3 (Y1)

Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination...

Description and Operation - Supplemental Climate Control - Component Location

Item Description 1 Front evaporator shutoff valve 2 High voltage battery coolant cooler 3 Electric booster heater Plug-In Hybrid Electric Vehicle (PHEV) Item Description 1 Cabin heater coolant temperature sensor 2 Cabin coolant heater 3 Cabin heater coolant diverter valve 4 Cabin heater coolant pump ..

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - Tie Rod End

Special Tool(s) / General Equipment Tie Rod End Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: Left hand (LH) side shown, right hand (RH) side similar. Remove the wheel and tire. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation). Loosen the tie rod end jam nut. Torque: ..

Ford Escape 2020-2026 Service Manual: General Procedures - Finish Panel Repair

Repair NOTE: Mouldings located on the front and rear window frames may experience minor scratches from vehicle shipment or car wash racks. The imperfections may be repaired instead of replacing components by following the steps below. NOTE: Scratches deep enough to cause a thumb nail to catch cannot be repaired and the component must be replaced. Clean with a mild soap and wate..