Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the upper belt moulding screw at front of the door.
Torque:
8 lb.in (0.9 Nm)
Remove the upper belt moulding screw at rear of the door...
Bring the engine to normal operating temperature. Connect
the Vacuum/Pressure Tester to the intake manifold. Run the engine at the
specified idle speed.
The vacuum gauge should read between 51-74 kPa (15-22 in-Hg)
depending upon the engine condition and the altitude at which the test
is conducted...