Other information:
Gate Operator / Canadian Programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission –
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators “time-out” in the
same manner.
Note: If programming a garage door opener
or gate ope..
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if the SODL or SODR is being replaced.
NOTE:
This procedure can be used for all locations of the component.
Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19..