Ford Escape: Exterior Lighting / Exterior Lighting Control

- Lamps off.
- Parking lamps on.
- Autolamps on.
- Headlamps on.
Rotate the control to make a selection.
Note: The lighting control defaults to
autolamps every time you switch your
vehicle on.
Using the High Beam Headlamps
Push the lever away from you to
switch the high beams on.
Push the lever forward again or pull the
lever toward you to switch the high beams
off...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
ABS
B10DA:51
PATS Target Identifier: Not Programmed
GO to Pinpoint Test P
ABS
C0001:01
TCS Control Channel 'A' Va..
Check
WARNING:
Invisible ultraviolet and infrared rays emitted in welding
can injure unprotected eyes and skin. Always use protection such as a
welder's helmet with dark-colored filter lenses of the correct density.
Electric welding will produce intense radiation, therefore, filter plate
lenses of the deepest shade providing adequate visibility are
recommended. It is strongly reco..