Ford Escape: Exterior Lighting / Headlamps
Using the High Beam Headlamps

Push the lever away from you to
switch the high beams on.
Push the lever forward again or pull the
lever toward you to switch the high beams
off.
Slightly pull the lever toward you and
release it to flash the headlamps.
Switching Headlamp Exit Delay On and Off
To switch headlamp exit delay on, pull the
turn signal lever toward you after switching
your vehicle off.
To switch headlamp exit delay off, pull the
turn signal lever toward you again or switch
your vehicle on.
Note: The headlamps turn off after three
minutes with any door open or 30 seconds
after the last door closes.
Headlamp Indicators
Lamps On
Illuminates when you switch the
low beam headlamps or the
parking lamps on.
Headlamp High Beam
Illuminates when you switch the
high beam headlamps on.
Lamps off.
Parking lamps on.
Autolamps on.
Headlamps on.
Rotate the control to make a selection.
Note: The lighting control defaults to
autolamps every time you switch your
vehicle on...
Headlamps – Frequently Asked Questions
Why is there condensation in the headlamps?
Headlamps have vents to
accommodate normal changes in air
pressure...
Other information:
System Operation
Exhaust Gas Recirculation (EGR) Systems
The EGR system controls the NOX
emissions. Small amounts of exhaust gases are recirculated back into
the combustion chamber to mix with the air to fuel charge. The
combustion chamber temperature is reduced, lowering NOX emissions
Exhaust Gas Recirculation (EGR) System — Differential Pressure Feedback
The EGR system consists o..
Removal
NOTE:
Driver seat shown, passenger seat similar.
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
Remove the front seat side shield screws.
Firmly grasp the front seat side shield, lift up and
out, separating the side shield from the recliner bracket.
Slide the front s..