Ford Escape 2020-2026 Service Manual / Powertrain / Engine / Engine System - General Information / General Procedures - Camshaft Surface Inspection

Ford Escape: Engine System - General Information / General Procedures - Camshaft Surface Inspection

Inspect the camshaft lobes for pitting or damage in the active area. Minor pitting is acceptable outside the active area. The active area includes the opening ramp and closing ramp. The opening ramp is the point where the lifter just begins to lift until the point it reaches the nose of the lobe. The closing ramp is the point from the nose back down to the lash point. The base circle of the camshaft is not the active area.

General Procedures - Bearing Inspection

I..

General Procedures - Compression and Cylinder Leakage Test

Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged. Operate the vehicle until the engine is at normal operating temperature...

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Battery Disconnect and Connect

Disconnect NOTE: When the battery is disconnected and connected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven to allow the PCM to relearn the adaptive strategy values...

Ford Escape 2020-2026 Service Manual: Removal - Engine

Special Tool(s) / General Equipment 303-476 (T94P-9472-A) Socket, Exhaust Gas Oxygen SensorTKIT-1994-LM/MTKIT-1994-FTKIT-1994-FLM/FM Strap Wrench Floor Crane Adjustable Mounting Arm Oil Drain Equipment Hose Clamp Remover/Installer Fluid Container Punch Powertrain Jack Wooden Block Copper Hammer Materials Name Specification Mot..

Vehicle Identification

Locating the Vehicle Identification Number

The vehicle identification number is on the left-hand side of the instrument panel.

Ford Escape. Vehicle Identification