Ford Escape 2020-2026 Owners Manual / Child Safety / Installing Child Restraints

Ford Escape: Child Safety / Installing Child Restraints

Child Restraints

Child Restraint Position Information Install the child restraint tightly against the vehicle seat. It may be necessary to lift or remove the head restraint...

WARNING: Depending on where you secure a child restraint, and depending on the child restraint design, you may block access to certain seatbelt buckle assemblies and LATCH lower anchors, rendering those features potentially unusable...

Other information:

Ford Escape 2020-2026 Service Manual: Diagnosis and Testing - Body System

Global Customer Symptom Code (GCSC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Symptom Action Fit/Finish/Body > Water Leak > Passenger Area > Appearance GO to Pinpoint Test A Fit/Finish/Body > Water Leak >..

Ford Escape 2020-2026 Service Manual: Removal and Installation - Rear Active Park Assist Sensors

Removal NOTE: RH side shown, LH side similar. Remove the rear wheel and tire. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation). Remove the screw. Torque: 17 lb.in (1.9 Nm) Remove the push pins and position aside the rear wheel arch liner. Remove the active park assist sensor. ..

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.