Other information:
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion chamber side of the
valve guide, if necessary.
Use a ball gauge to determine the inside diameter of
the valve guides in 2 directions at the top, middle and bottom of the
valve guide...
Special Tool(s) /
General Equipment
100-001
(T50T-100-A)
Slide Hammer
Materials
Name
Specification
Motorcraft® Threadlock and SealerTA-25-B
-
Repair
All core plugs
NOTE:
Cylinder block core plug shown, cylinder head core plug similar...