Ford Escape: Electronic Feature Group / Lane Keeping System

Removal and Installation - Side Obstacle Detection Control Module (SODCM)

Removal Side obstacle detection control module NOTE: This step is only necessary if the SODL or SODR is being replaced. NOTE: This procedure can be used for all locations of the component...

Description and Operation - Lane Keeping System - Component Location

Component Location - Lane Keeping System Item Description 1 IPMA 2 Lane Keeping System (LKS) switch (integral to the LH steering column multifunction switch) ..

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Tire Pressure Monitoring System (TPMS) Sensor Location Calibration

Special Tool(s) / General Equipment 204-D081A (204-D081) Tire Pressure Monitor (TPMS) Ford Diagnostic Equipment Programming NOTE: The TPMS can be placed into learn mode using a diagnostic scan tool or manually where a diagnostic scan tool is not available. NOTE: The horn will sound once and the TPMS indicator will flash if the training mode has been entered successful..

Ford Escape 2020-2026 Service Manual: Description and Operation - Engine Ignition - System Operation and Component Description

System Operation Cold Start Emission Reduction Monitor The cold start emission reduction monitor is an on board strategy designed for vehicles that meet the low emissions vehicle-II (LEV-II) emissions standards. The monitor works by detecting the lack of catalyst warm up resulting from a failure to apply sufficient cold start emission reduction during a cold start. There are 2 types of m..