Ford Escape: Doors and Locks / Operating the Doors From Outside Your Vehicle
Unlocking and Locking the Doors Using the Remote Control
You can only use the remote control when
your vehicle is stationary.
Unlocking the Doors
Press the button to unlock all
doors.
Locking the Doors
Press the button to lock all
doors. One short flash of the
turn signal lamps confirms that
your vehicle has locked.
Note: For more information on operating
the doors from outside your vehicle See
Keyless Entry.
Unlocking and Locking the Doors Using the Key Blade
If there is a power door lock fault, you can
use the key blade to lock and unlock the
driver door.

- Lock.
- Unlock.
Individually Unlocking and Locking the Doors Using the Key Blade
If there is a power door lock fault you can
use the key blade to lock and unlock the
doors.

- Lock.
- Unlock.
Unlocking and Locking the Doors Using the Central Locking
The power door lock control is on the driver
door.
Press the button to unlock all
doors.
Press the button to lock all
doors...
Other information:
What Is Automatic Return to Park (P)
Your vehicle shifts into park (P) if you
attempt to exit your vehicle without the
transmission in park (P).
How Does Automatic Return to Park (P) Work
Your vehicle shifts into park (P) when your
vehicle is stationary and any of the
following occur:
You switch the vehicle off...
What are the Alarm Security Levels
You can select two levels of alarm security,
all sensors and perimeter sensing.
All Sensors
All sensors is the standard setting.
In all sensors, all equipped sensors are on
when you arm the alarm.
Note: Do not arm the alarm with all sensors
if passengers, animals or other moving
objects are inside your vehicle...
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more