Ford Escape: Fuel Charging and Controls / Removal and Installation - Fuel Injectors
Removal and Installation
-
The fuel injectors are removed with the fuel rail.
Refer to: Port Injection Fuel Rail (303-04C Fuel Charging and Controls, Removal and Installation).
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
Position the second row left seat back all the way
forward, then raise front of the rear load floor up and out of the way.
Raise the left front corner of the left load compartment floor support up and out of the way...
Other information:
Washer Precautions
WARNING: If you operate your
vehicle in temperatures below 41°F
(5°C), use washer fluid with antifreeze
protection. Failure to use washer fluid
with antifreeze protection in cold
weather could result in impaired
windshield vision and increase the risk
of injury or accident...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the LH fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels).
Disconnect the CSI electrical connector, detach the retainer and position the wire harness aside...