Other information:
Disconnect the high voltage connector.For additional information,
refer to: High Voltage Connector Disconnect and Connect (414-03A High
Voltage Battery, Mounting and Cables, General Procedures).
NOTE:
It is necessary to disconnect the battery to avoid
setting any DTCs that could cause the PCM to command the oil pressure to
other than what should be observed from a correctly ..
Removal
All vehicles
NOTE:
If installing a new PAM
, it is necessary to upload the module configuration information to the
scan tool prior to removing the module. This information must be
downloaded into the new PAM after installation.
Using a diagnostic scan tool, begin the PMI process for the PAM following the onscreen instructions.
Remove the floor console.
R..