Ford Escape Manuals

Ford Escape: Battery and Charging System / Voltage Converter/Inverter

Removal and Installation - Charge Status Indicator (CSI) - Plug-In Hybrid Electric Vehicle (PHEV)

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the LH fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels)...

Description and Operation - Direct Current/Direct Current (DC/DC) Converter Control Module - Component Location

Item Description 1 Direct Current/Direct Current (DC/DC) Converter Control Module ..

Other information:

Ford Escape 2020-2025 Service Manual: Removal and Installation - Rear Door Upper Moulding


Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the upper belt moulding screw at front of the door. Torque: 8 lb.in (0.9 Nm) Remove the upper belt moulding screw at rear of the door. Torque: 8 lb.in (0.9 Nm) Lift the moulding ..

Ford Escape 2020-2025 Owners Manual: Autounlock. Autolock. Mislock. Doors and Locks Audible Warnings


Autounlock What Is Autounlock Autounlock is an unlocking feature that unlocks the vehicle doors when your vehicle comes to a stop. Autounlock Requirements Autounlock unlocks all the doors when all of the following occur: The ignition is on, all the doors are closed and your vehicle is moving at a speed greater than 12 mph (20 km/h). Your vehicle comes to a stop. You open the driver door..

Categories

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.

read more

Copyright © 2025 www.fordescape4.com