Ford Escape: Glass, Frames and Mechanisms / Description and Operation - Glass, Frames and Mechanisms - Vehicles With: One-Touch Open Driver Window - Overview
Overview
Power Window Operation
The
power windows operate only when the ignition is on, or up to 10 minutes
after the ignition is changed from on to off while the front driver and
passenger doors remain closed. Standard power window features include
one-touch down operation (driver door window only) when the driver
window control switch is momentarily pressed to the second detent and
released. The window control switch:
-
can manually raise/lower all windows from the driver
window control switch or the individual passenger window from the
corresponding door switch.
-
has a rear passenger window lock out feature (located on the driver window control switch).
Rear Window Defrost
Press the rear window defrost switch (integral to the HVAC module)
to activate the rear window defrost. The rear window defrost
automatically turns off after a short period of time.
Overview
Power Window Operation
The
power windows operate only when the ignition is on, or up to 10 minutes
after the ignition is changed from on to off while the front driver and
passenger doors remain closed...
System Operation
System Diagram - Power Windows
Driver Side Power Windows
Item
Description
1
LIN
2
Driver Side Front Window Motor
3
Driver Side Rear Window Control Switch
4
Driver Window Control Switch
5
DDM
6
Driver Side Rear Window Motor
Passenger Side Power Windows
Item
Description
1
Passenger Fr..
Other information:
Special Tool(s) /
General Equipment
Tie Rod End Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Left hand (LH) side shown, right hand (RH) side similar.
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Loosen the tie rod end jam nut.
Torque:
..
Check
NOTE:
Refer to the appropriate Section 303-01 for the specifications.
NOTE:
The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
Measure the cylinder bore in 2 directions.
Select a piston size based on the cylinder bore.
NOTE:
For precision fit, new pistons are divided into 3 ..