Ford Escape: Instrument Cluster / Instrument Cluster Overview - Plug-In Hybrid Electric Vehicle (PHEV),
Vehicles With: 12.3 Inch Instrument Cluster Display Screen

- Coolant temperature gauge.
- Speedometer.
- Information bar.
- Instrument cluster display.
- Battery gauge and vehicle driving range.
- Power gauge.
- Fuel gauge.
Power gauge.
Information bar.
Speedometer.
Fuel gauge.
Battery gauge and vehicle driving range.
Instrument cluster display.
Engine coolant temperature gauge...
(IF EQUIPPED)
Shows the engine speed. The red line
thickens where the engine speed enters
the overspeed limiter.
..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the following items:
Dislodge and position aside the air cleaner intake pipe.
Remove the clips.
Dislodge the air intake pipe and remove it from location.
Installation
To install, reverse the removal procedure.
..
Special Tool(s) /
General Equipment
Punch
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the aft rear door upper moulding.
Refer to: Rear Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Remove the upper inter..
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more