Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the upper belt moulding screw at front of the door.
Torque:
8 lb.in (0.9 Nm)
Remove the upper belt moulding screw at rear of the door...
Configuration
NOTE:
The inverter system controller (ISC) is called the SOBDMC
(secondary on-board diagnostic control module C) in the scan tool.
Using the scan tool, enter the transmission 11-digit
identification and 13-digit strategy recorded from the transmission tag...