Other information:
Check
NOTE:
The object used in this system check can be
fabricated using a 9 cm diameter (3 in I.D.) pipe, 100 cm (39 in) in
length (available as Polyvinyl Chloride (PVC) pipe, or similar from a
hardware or plumbing supply.
NOTE:
The following system check should be carried out with the vehicle on a level surface...
Special Tool(s) /
General Equipment
Punch
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the aft rear door upper moulding...