Ford Escape: Evaporative Emissions / Removal and Installation - Evaporative Emission System Leak Detection Pump - Plug-In Hybrid Electric Vehicle (PHEV)
Removal
NOTE:
The evaporative emission system leak detection pump is serviced with the EVAP canister
-
Refer to: Evaporative Emission Canister - Plug-In Hybrid Electric
Vehicle (PHEV) (303-13C Evaporative Emissions, Removal and
Installation).
Installation
-
To install, reverse the removal procedure.
Removal
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of
any type when working on or near any fuel-related component...
Removal
NOTE:
The evaporative emission system leak detection pump is serviced with the EVAP canister
Refer to: Evaporative Emission Canister - Hybrid Electric Vehicle (HEV)
(303-13C Evaporative Emissions, Removal and Installation)...
Other information:
Materials
Name
Specification
Motorcraft® High Temperature Nickel Anti-Seize LubricantXL-2
-
Removal
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting)
.
NOTICE:
Do not use heat to loosen a seized wheel nut or damage to the wheel and wheel bearing can occur...
Special Tool(s) /
General Equipment
303-1416Tool, Crank Damper HoldingTKIT-2008ET-FLM
303-1699Tool, Crank Sensor Alignment
303-465Tool, Camshaft Align TimingTKIT-1994-LMH/MH2TKIT-1994-FH/FMH/FLMH
303-507Timing Peg, Crankshaft TDCTKIT-2001N-FLMTKIT-2001N-ROW
Trolley Jack
Wooden Block
Removal
NOTICE:
Do not loosen or remove the crankshaft pulley bolt..