Ford Escape: Handles, Locks, Latches and Entry Systems / Removal and Installation - Keyless Entry Keypad
Removal
NOTE:
The keyless entry keypad is serviced as an assembly with the front door upper moulding.
-
Remove the front door upper moulding.
Refer to: Front Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
-
If the door is equipped with one touch up/down, carry out the power door window initialization.
Refer to: Power Door Window Initialization - Vehicles With: One-Touch
Open and Close Front Windows (501-11 Glass, Frames and Mechanisms,
General Procedures).
Removal
NOTE:
Left hand (LH) shown, right hand (RH) similar.
NOTE:
Typical interior rear door handle latch release cable clip shown, others similar...
Removal
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the keyless entry rear antenna...
Other information:
Distance Alert
What Is Distance Alert
The system alerts you with a warning lamp
if the distance to the vehicle ahead is
small.
Note: The warning lamp does not
illuminate if cruise control or adaptive cruise
control is active.
Adjusting the Sensitivity of Distance Alert
To adjust the sensitivity of the system, use
the touchscreen:
Press Settings on the touchscreen...
Deep Snow/Sand (If Equipped)
Use this mode to aid you in
getting your vehicle unstuck
from deep snow or sand.
Note: The intent of your all-wheel drive
vehicle is not for off-road use. The all-wheel
drive feature allows for driving on relatively
level surfaces, obstruction free and similar
to normal on-road driving conditions...