Ford Escape 2020-2026 Service Manual / Chassis / Suspension / Wheels and Tires / Specifications

Ford Escape: Wheels and Tires / Specifications

General Specifications

Item	Specification
Tire Inflation
Tires	See Safety Certification Label on driver door jamb
Wheel Weights
Wheel weight type	Use a wheel weight manufacturer's rim gauge to determine the correct wheel weight application

Torque Specifications

Item	Nm	lb-ft	lb-in
Valve stem-to-TPMS sensor screw	1.5	—	13
Wheel nutsa	—	—	—

aRefer to the procedure in this section.

Wheels and Tires

Description and Operation - Safety Precautions - Overview

Overview Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury...

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Key Programming Using Two Programmed Keys

Programming NOTE: This procedure works only if the spare key programming is enabled. NOTE: Two previously programmed keys are required to perform this procedure. All the steps must be completed within 30 seconds. NOTE: Make sure all the doors are closed prior to beginning this procedure and they remain closed until the procedure is complete...

Ford Escape 2020-2026 Service Manual: General Procedures - Oil Pressure Test

NOTE: It is necessary to disconnect the battery to avoid setting any DTCs that could cause the PCM to command the oil pressure to other than what should be observed from a correctly operating system during the oil pressure test. Disconnect the battery ground cable...

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.