Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair.
Using a diagnostic scan tool, begin..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH fender splash shield.
Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
Remove the retainer and the ground wire.
Torque:
106 lb.in (12 Nm)
Disconnect the electrical connectors.
Detach the wiring harness ..