Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Using a non-marring tool release and position the light sensor.
Use the General Equipment: Interior Trim Remover
Disconnect the electrical connector and remove the light sensor.
..
Check
NOTICE:
Non-Hunter brand balancers will not include the Ford-approved procedure for match-mounting in their software.
NOTICE:
Other balancing procedures that exist on non-Hunter brand equipment are not Ford approved and should not be used.
NOTE:
Road Force® values in illustrations are shown in pounds.
NOTE:
Match mounting is a technique used to reduce radial runout
or ..