Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the electrical connector, remove the retainer and the MAP sensor.
Torque:
35 lb.in (4 Nm)
Installation
To install, reverse the removal procedure.
..
Special Tool(s) /
General Equipment
Feeler Gauge
Check
Refer to: Valve Cover (303-01C Engine, Removal and Installation).
NOTE:
Turn the engine clockwise only, and only use the crankshaft bolt.
NOTE:
Before removing the camshafts, measure the
clearance of each valve at base circle, with the lobe pointed away from
the tappet. Failure to measure all clearan..