Ford Escape: Body and Paint / Body Repairs - Vehicle Specific Information and Tolerance Checks

General Procedures - Welding Precautions

Check   WARNING: Invisible ultraviolet and infrared rays emitted in welding can injure unprotected eyes and skin. Always use protection such as a welder's helmet with dark-colored filter lenses of the correct density...

Description and Operation - Body and Frame

Body The body consists of the following: Front frame rails constructed of high-strength Dual Phase (DP) 600 steel Rear frame rails constructed of Boron ultra high-strength steel Fender reinforcement tube constructed of Dual Phase (DP) 800 high-strength steel Fender apron assembly constructed of Dual Phase (DP) 600 high-strength steel Liftgate outer panel constructed..

Other information:

Ford Escape 2020-2025 Service Manual: Removal and Installation - Floor Console

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. Release the clips and remove the trim panel. Disconnect the electrical connectors. Release the clips and remove the RH floor console side trim panel. Use the General Equipment: Interior Trim Re..

Ford Escape 2020-2025 Service Manual: Description and Operation - Turbocharger - System Operation and Component Description

System Operation Turbocharger And Charge Air Cooler (CAC) Systems Turbocharger System A turbocharger is an exhaust gas driven device used to increase the power output of an engine by the turbocharger compressor increasing the pressure of the air entering the engine. The turbocharger uses exhaust gas energy to drive the turbine connected to the compressor. Compressing the air causes ..