Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the floor console.
Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
Release the clips and remove the LH trim panel.
Disconnect the electrical connector.
Release the clips and remove the trim panel...
Special Tool(s) /
General Equipment
205-1075Remover/Installer, Rear Drive Unit Front
Removal
Front bushings
NOTE:
LH shown, RH similar.
Remove the RDU .
Refer to: Axle Assembly (205-02 Rear Drive Axle/Differential, Removal and Installation).
Assemble the spindle and thrust washer of the special service tool.
Use Special Service Tool: 205-107..