Ford Escape: Parking Aid - Vehicles With: Rear Parking Aid / Description and Operation - Parking Aid - Component Location
Component Location, Parking Aid - Audible without 360 Degree View Camera
| Item |
Description |
| 1 |
Rear parking aid sensors |
| 2 |
Parking aid switch |
| 3 |
Front speakers (part of audio system) |
| 4 |
Front parking aid sensors |
| 5 |
Front active park assist sensors |
| 6 |
PAM
|
| 7 |
Rear speakers (part of audio system) |
| 8 |
Rear side sensors |
Parking Aid Overview
Parking Aid - Audible
The
available parking aid features depend on the vehicle trim level and
options selected. The possible audio parking aid configurations are as
follows:
Rear parking aid
Front and rear parking aid
Front and rear parking aid, plus active park assist and the side sensing system (also known as flank guard)
The
rear parking aid ..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the glove compartment and remove the check strap.
Fully lower the glove compartment.
Lift glove compartment off the hinge piviot.
Remove the bolts and the glove compartment close out.
Torque:
22 lb.in (2.5 Nm)
..
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-758Installer, Axle Seal -FWD
Flat Headed Screw Driver
Removal
Remove the power transfer unit.
Refer to: Power Transfer Unit (308-07E)
.
Remove and discard the RH halfshaft seal.
Use the General Equipment: Flat Headed Screw Driver
Installation
..
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more