Ford Escape: Power Brake Actuation / Description and Operation - Power Brake System - Vehicles With: Electric Brake Booster - Overview
Electric Brake Boost
Overview
The power assisted brake system utilizes an EBB . The EBB is an
integrated function of the ABS / HCU assembly and is controlled by the
ABS module. The ABS / HCU combines the functions of a conventional
vacuum booster and ABS module. The ABS module controls and monitors the
EBB function and sets Diagnostic Trouble Codes (DTCs) when a fault is
present in the system. The IPC illuminates the red brake warning
indicator and displays a message in the message center when a fault is
present.
System Operation
System Diagram - Electric Brake Boost
E347819
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
HS-CAN3
HS-CAN1
HS-CAN2
1
IPC
2
RCM
3
BCM
4
PCM
5
GWM
..
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
BCM
B1175:01
Drivers Door Ajar Switch: General Electrical Failure
GO to Pinpoint Test A
BCM
B1175:01
Drivers Door..
Special Tool(s) /
General Equipment
Master Cylinder Bleeding Set
Bleeding
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
Master Cylinder
NOTE:
When a new brake master cylinder has been installed, it
should be primed to prevent air from entering the system.
NOTE:
Make sure the area around the ..