Ford Escape: Tire Pressure Monitoring System (TPMS) / Description and Operation - Tire Pressure Monitoring System (TPMS) -
Vehicles Without: Keyless Entry and Push Button Start - Overview
Overview
The BCM uses tire pressure sensors to monitor tire pressure. The
sensors use radio signals to transmit the tire pressure to the BCM .
The tire pressure sensors are battery operated and mounted to the valve stems.
The IPC illuminates the TPMS
warning indicator and the message center displays a message when a
fault is present or when the tire pressure falls below the low pressure
limit.
System Operation
System Diagram
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
IPC
E344854
2
TPMS
Sensor
3
TPMS
Sensor
4
TPMS
Sensor
5
TPMS
Sensor
6
GWM
7
IPC
Message
Center
Display
8
TPMS
Warni..
Other information:
Post-Crash Alert System
What Is the Post-Crash Alert System
The system helps draw attention to your
vehicle in the event of a serious impact.
How Does the Post-Crash Alert System Work
The system is designed to turn the hazard
flashers on and to intermittently sound the
horn in the event of a serious impact that
deploys an airbag or the seatbelt
pretensioners.
Post-Crash Alert System Limitatio..
Special Tool(s) /
General Equipment
307-805Alignment Pins (2)
Ford Diagnostic Equipment
Removal
NOTE:
This step is only necessary when installing a new transmission or ISC (Inverter System Controller).
Download the module information to the diagnostic tool using the Programmable Modules Installation routine.
Use the General Equipment: Ford Diagnostic Equipment
..
Categories
What Is the Master Access Code
The master access code is a factory-set
five-digit entry code. You can operate the
keypad with the master access code at
any time. The master access code is on the
owner’s wallet card in the glove box and
is available from an authorized dealer.
Displaying the Master Access Code
To display the factory-set code in the
information display:

Remove the rubber mat.
Insert the first programmed key in the
backup slot.
Press the push button ignition switch
once and wait a few seconds.
Press the push button ignition switch
again and remove the key.
Within 10 seconds, place a second
programmed intelligent access key in
the backup slot and press the push
button ignition switch.
read more