Ford Escape: Wipers and Washers / Description and Operation - Wipers and Washers - Overview
Overview
The
windshield wiper/washer system is activated by the wiper/washer switch.
The wiper/washer switch is mounted to the right side of the SCCM . The
following functions/ features of the windshield wiper/washer system are:
-
Mist wipe
-
Windshield wash (includes front camera wash, if equipped)
-
Courtesy wipe
-
Windshield wipers (low/high speed)
-
Intermittent wipers
-
Speed dependent wipers
-
Wiper activated exterior lamps
-
Rain sensitive wipers (if equipped)
-
Rear window wipe/wash
-
Heated wiper park (if equipped)
The intermittent/rain sensitive wipers have 6 intermittent /sensitivity settings.
System Operation
System Diagram
Item
Description
1
Rain Sensor
2
SCCM
3
GWM
4
BCM
5
IPC
6
PCM
7
BCMC
8
Wiper Relay
9
BCMC
10
Rear Washer Relay
11
Rear Wiper Motor
12
Washer Motor
13
Windshield Wiper Motor
14
HS-CAN3
15
LIN LIN
16
HS-CA..
Other information:
Special Tool(s) /
General Equipment
204-069
(T81P-1104-C)
Remover/Installer, Front Wheel Hub
205-153
(T80T-4000-W)
Handle
307-557Installer, Ball BearingTKIT-2005U-FLMTKIT-2005U-LMTKIT-2006U-FLM/LMTKIT-2006UF/FM
308-968Installer, Input Shaft Seal
308-971Remover, Input Sleeve
308-972Installer, Input Sleeve
308-973Remover, PTU Input Sleeve
Hyd..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the center registers.
Refer to: Center Registers (412-00 Climate Control System - General Information, Removal and Installation).
Release the tabs and remove the hazard flasher switch from the center registers.
Installation
To install, reverse..