Ford Escape Manuals
Ford Escape 2020-2026 Service Manual / Body and Paint / Body and Paint / Wipers and Washers / Removal and Installation - Windshield Washer Fluid Level Sensor

Ford Escape: Wipers and Washers / Removal and Installation - Windshield Washer Fluid Level Sensor

Materials

Name Specification
Motorcraft® Premium Windshield Wash Concentrate with Bitterant
ZC-32-B2		 WSS-M14P19-A
 

Removal

  1. Remove the windshield washer reservoir.
    Refer to: Windshield Washer Reservoir (501-16 Wipers and Washers, Removal and Installation).
    1. Disconnect the electrical connector.

    1. NOTE: Be prepared to collect escaping fluid.

      Remove the windshield washer fluid level sensor.

Installation

  1. NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow this instruction may result in premature pump failure.

    To install, reverse the removal procedure.
    Material: Motorcraft® Premium Windshield Wash Concentrate with Bitterant / ZC-32-B2 (WSS-M14P19-A)

    Removal and Installation - Rear Window Wiper Pivot Arm

    Special Tool(s) / General Equipment Two Leg Puller Removal Open the rear pivot arm nut cover. Remove the rear wiper pivot arm nut...

    Removal and Installation - Windshield Washer Pump

    Materials Name Specification Motorcraft® Premium Windshield Wash Concentrate with BitterantZC-32-B2 WSS-M14P19-A  Removal Remove the windshield washer reservoir...

    Other information:

    Ford Escape 2020-2026 Service Manual: Removal and Installation - Front Door Side Impact Sensor


    Removal   WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash...

    Ford Escape 2020-2026 Service Manual: Removal and Installation - Body Control Module C (BCMC)


    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If the BCMC (body control module C) did not respond to the diagnostic scan tool, As-Built Data may need to be entered as part of the repair. This step is only necessary if the BCMC (body control module C) is being replaced...

    Categories

    Vehicle Identification

    Locating the Vehicle Identification Number

    The vehicle identification number is on the left-hand side of the instrument panel.

    Ford Escape. Vehicle Identification

    read more

    Copyright © 2026 www.fordescape4.com